Insulation Winding Wire
0102030405
Polyester/Polyimide Covered Winding Wire
The DetailsHeg
Polyimide film is coated with a high temperature resistant binder and coated with a polyimide film strip. After heating, the thin film band becomes a continuous insulating layer. The winding wire has high temperature, low temperature and radiation resistance, the sealing, electrical and wear resistance. It is applied to steel rolling motor high temperature operation, traction motor, deep well pump motor and dry Transformer coil.
For Aromatic polyimide tape-covered aluminum magnet wire, after the aluminum magnet wire is taped with a tape that is 1.5 mm thick with 1.0 mm of this thickness being polyimide film and the remaining 0.5 mm being fluoroplastic, it is heated and heat-sealed.
Breakdown voltage of polyimide film covered copper/aluminum wireHeg
|
Wrapping method |
Insulation thickness (mm) |
Breakdown voltage above |
|
|
Nominal value |
Tolerance |
||
| Two layers polyimide self-locking wrapping |
0.15 |
±0.03 |
6000 |
| Two layers of polymide lap wrapped in opposite directions |
0.15 |
±0.03 |
6000 |
| Three layers of polyimide lap wrapped in oppsite directions |
0.23 |
±0.03 |
7000 |
Product breakdown voltage should follow below table(Non woven fabric/polyester film wrapping)Heg
|
Wrapping type |
Insulation Thickness(mm) |
Breakdown voltage above |
|
| Standard Value |
Tolerance |
||
| Two layers of polyester films |
0.22 |
±0.03 |
5000 |
| Two layers of polyester films+one layer of non-woven fabrics |
0.33 |
±0.03 |
5000 |
| Three layers of polyester films |
0.3 |
±0.03 |
7500 |
| Three layers of polyesters film+non-woven fabrics |
0.42 |
±0.03 |
7500 |